Solution for Installing 18-1/4" x 12" Holding Tank Heater Pad # 277-000164
Question:
hi I see that the directions say I need minimum 60F to install them. Im up in Canada and this time of year it might gt to 50 F tops during the day. Any suggestions on how I can get them on before it gets any colder. Thanks.
asked by: Matt D
0
Expert Reply:
You do want to be in a warmer temperatures to install the # 277-000164 so that the adhesive sticks properly. If you have access to a blow dryer you could lightly heat up the area with it and then keep it warm for several minutes after application and I am sure you'd be fine.
There is a bit of irony in having to heat up a heater to properly install it though!
expert reply by:
Jameson C
0
Product Page this Question was Asked From
ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat - 18-1/4" Long x 12" Wide
- RV Fresh Water
- Winterization
- Holding Tank Heating Pad
- LaSalle Bristol
more information >
Continue Researching
- Q&A: Is there a flat towing base plate that will work with this grille guard installed on a 2019 Jeep Wra
- Q&A: Can RV Water Tank Heating Pads be Used on Black and Gray Water Tanks
- Q&A: Wiring Multiple Heater Pads to an On/Off Switch
- Q&A: How To Reattach RV Holding Tank Heating Pad If Self-Adhesive Comes Loose
- Article: Trailer Wiring Diagrams
- Q&A: Can Thermaheat RV Holding Tank Heater part # 277-000164 Work with 12 Volts
- Q&A: Difference Between the Blue Ox Alpha and Avail Tow Bars
- Q&A: What is Most Common Trailer Wheel 6 Lug Bolt Pattern
- Article: 7 Facts About RV Antifreeze Every RVer Should Know
- Article: Best Air Bag Suspension (2023)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2019 Jeep Cherokee
- Article: How to Survive the Winter In Your RV