Could CE Smith Galvanized Steel Step # CE26212G-15284GA Be Used on 3 inch Wide Frame
Question:
Id like to mount these on my trailer tongue which is 3 x 5 do you have u bolts that will fit? I looks like the mounting slots are wide enough. Otherwise, do you have a galvanized strip with 3 inch hole spacing so that bolts could be used? Thanks,
asked by: Cal
0
Expert Reply:
What you can do instead is get the # CE26212G, and then purchase the U-bolts you need to fit your trailer. We don't have any for a 3 inch frame width, but as long as the bolt is 9/16 or 1/2 inch diameter it will work in the slotted mounting holes.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Galvanized Steel Step for Trailer Fender - 15-1/4" Long x 3" Wide - Qty 1
- Boat Trailer Parts
- Steps
- 3 Inch Wide
- 15-1/4 Inch Long
- CE Smith
more information >
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Article: Trailer Wiring Diagrams
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Q&A: Replacement Amber Lens for Trailer Light with SAE A P2 DOT 14
- Q&A: Best Replacement for Old 6.00-16 Trailer Tires
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Overview of Lubricating Grease
- Article: Rust Prevention
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Boat Trailer Showdown: Bunks vs. Rollers