Does Power Wire for Peterson 138A Clearance Light Connect to Ground of Other Clearance Light
Question:
I have the hot wire and understand that that is connected to the wire included with the light. However, there is a second wire that goes to the next light. How do I connect that... where? These lights are in series, right?
asked by: Theresa F
0
Expert Reply:
You'd need to run your other lights power wire to the same power source as what the # 425600 will connect to. These are not wire like Christmas lights where the power of one light is the ground of the next.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Peterson Double Bullseye Clearance and Side Marker Trailer Light - 2 Bulbs - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 2W Inch
- Amber
- Peterson
more information >
Continue Researching
- Q&A: Cross Reference a Replacement for a TCM 21334 TB Grease Seal
- Q&A: Is There 5,200 lb Trailer Hub that has 8 Lug Bolt Pattern
- Article: Trailer Wiring Diagrams
- Q&A: Measurements of Replacement Lens Tail Light 2423286
- Q&A: Is Optronics Trailer Tail Light # ST70RB the Same As Petersen Trailer Tail Light # M421KR
- Q&A: Best Size 6.70-15 Tire Replacements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How Do I Convert My Incandescent Trailer Lights to LED Lights
- Q&A: Proper Way to Tighten Trailer Spindle of Castle Nut
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Lighting Requirements
- Article: 2023 Best Gifts for Haulers & Towers
- Article: 2023 Best Gifts for RVers & Campers
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)