Recommended TorkLift Custom Camper Tie-Downs for 2004 Dodge Ram 1500 4WD w/ Factory Hitch
Question:
Have factory installed class IV hitch and its 4WD
asked by: Michael C
0
Expert Reply:
If your 2004 Dodge Ram 1500 4WD has a 6-1/2 foot bed and does not have a board or step underneath the truck bed, the correct TorkLift Custom Frame-Mounted Camper Tie-Downs is part # TLD2105 for the front and # TLD3109 for the rear. These are confirmed to fit to your truck that has the factory trailer hitch installed.
I have attached the written installation details and a couple demonstration videos on this product that you can also check out.
expert reply by:
Chris R
0
Products Referenced in This Question
TorkLift Camper Tie-Downs - Custom Frame Mount - Rear
- Camper Tie-Downs
- Rear Tie-Downs
- Frame-Mounted
- Custom Fit
- Powder Coated Steel
- TorkLift
more information >
Product Page this Question was Asked From
TorkLift Camper Tie-Downs - Custom Frame Mount - Front
- Camper Tie-Downs
- Front Tie-Downs
- Frame-Mounted
- Custom Fit
- Powder Coated Steel
- TorkLift
more information >
Continue Researching
- Q&A: How To Obtain the Offset Lift Brackets for a Curt MV Weight Distribution System
- Article: How to Mount a Truck Bed Camper
- Q&A: Does Truck Bed Remove to Install HappiJac Tie Down Anchors on 2005 GMC Sierra 3500
- Q&A: Rear Anchor Installation Instructions For HappiJack Truck-Mounted Tie Downs
- Q&A: Which Brake Assembly Does Part Numbers B10E-21 & B10E-22 Correspond to?
- Q&A: How to Determine Fitment of the Brophy Camper Tie Downs in a 1968 Ford F-250 Camper Special
- Q&A: Camper Tie-Downs for a 2013 Ford F-150
- Article: Adding Electric Over Hydraulic Disc Brakes
- Q&A: Outside Diameter of Hitch Extender for Brophy Hitch-Mounted Stairs