How Would Rivets Remove on Trailer to Install the Redline Roof Vent # RV-626-062 In Place of it
Question:
Replacement Exterior Pop-Up Roof Vent - Aluminum - 13-1/2inch x 8 Item # RV-626-062 is the item that I need to replace my current trailer vents. However I cant not get my current vents removed, they are not attached with screws or a screw type object that I can remove - they look like screws or pegs with a hole in the middle think of a donut any idea how to remove the current vents so that I can install the new ones? Thank you
asked by: Julie
Expert Reply:
What you described are rivets. They have to be drilled out as they don't have a nut or screw that unthreads.
You want to find a drill bit thats about half the diameter of the rivet and then drill it through the rivet to pop it off.
Product Page this Question was Asked From
Replacement Exterior Pop-Up Roof Vent - Aluminum - 13-1/2" x 8"
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 2-1/2 Inch
- No Fan
- 8W x 13-1/2L Inch
- Metal
- Silver
- Redline
more information >
Continue Researching
- Q&A: RV Fridge Vent Cover Availability for 23-3/8 inch by 6-1/2 inch Cut Out
- Q&A: Are There Any Replacement Roof Vents Available for the Discontinued Dometic Americana Refrigerator?
- Q&A: Lid Dimensions Of The Redline Exterior Pop Up Roof Vent
- Q&A: RV Refrigerator Vent and Cap Options For a 2003 Fleetwood Terry Travel Trailer
- Q&A: Where to Install Redline 2-Way Pop-Up Roof Vent and How to Open It
- Q&A: Can The Lid Of The Replacement Exterior Pop-Up Roof Vent # RV-626-062 Be Removed
- Q&A: How Does the Top of the Exterior Pop-Up Roof Vent Stay On
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Where to Position the Trailer Axle?
- Article: Determining Trailer Tongue Weight
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Measuring a Trailer Tire