Recommended Wheel for Bulldog Round, A-Frame Jack # BD155032
Question:
I am looking to replace the existing bulldog on my 3 horse trailer. It must have been damaged at some point prior to my purchase, and appears a couple inches have been cut off the end and a heavy round plate welded on. This means I cannot install a wheel, which makes hook up so much easier as I can move the front of the trailer an inch or two from side to side for alignment to the hitch. It also becomes extremely hard to crank about half way through the range. The lift is not sufficient to clear the hitch so requires about 8 inch of blocks under the jack! I have to determine if the lift will suffice on my trailer, but the addition of a wheel will impact that and make hooking up easier Do you recommended a specific wheel for this jack and application? Thank you
asked by: Niki
Helpful Expert Reply:
The wheel that is designed to work with the Bulldog Round, A-Frame Jack # BD155032 that you referenced can be found on our site as part # BD500245. You will simply need to remove the pin, install the wheel, and then reinsert the pin to use the wheel. It does have a weight rating of 1,500 lbs so you will want to make sure that your Tongue Weight (TW) is compatible before using the wheel.
If you would like to have the option of using a footplate for certain applications, you can use part # JF-99 which is rated for up to 5,000 lbs. This is a bolt-on application.
I have attached some installation videos that you can use as a reference.
Products Referenced in This Question
Replacement 6" Caster Wheel for Bulldog Trailer Jack with 2" Tube Diameter - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Wheel
- 6 Inch Wheel
- Wheel w Caster Assembly
- Bulldog
more information >
Footplate for 2,000-lb and 5,000-lb Round, A-Frame Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Jack Foot
- etrailer
more information >
Product Page this Question was Asked From
Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 4001 - 5000 lbs
- Topwind Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacing Mobile Home Trailer Hub With a Hub that is Compatible with Standard Rims and Tires
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Article: Trailer Wiring Diagrams
- Q&A: Looking for Shorter A-Frame Jack to Clear my Tailgate
- Q&A: Can't Lower Truck Tailgate Because it Hits the Trailer Jack
- Q&A: Recommended 5,000lb Topwind Trailer Jack Replacement
- Q&A: Replacement Lens for LED Trailer Clearance or Side Marker Light with Reflex Reflector 328-K-59LB
- Q&A: Replacement Water Pump for Shur Flo 200-210-39
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Best Camper Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Jacks