How Much of the Pin Sticks Out in the Locked Position on Bolt-On Zinc Spring Latch Item # SL716
Question:
When pin is closed there by locking the gate in place what is the length of the pin from the bracket to the end. The straight end length, not the looped end that you pull on. I need to make sure this pin will reach the hole for the pin on the gate when this is mounted. Thank you in advance!
asked by: Jay
0
Expert Reply:
For the Bolt-On Zinc Spring Latch Item # SL716 the distance from the bracket to the end of the pin (when in the locked position) is approximately 1-1/8 inches.
expert reply by:
Michael H
0
Product Page this Question was Asked From
- Trailer Door Latch
- Latches
- Spring Latch
- Steel
- Non-Locking
- 7/16 Inch Pin Diameter
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Determining The Correct Replacement Suspension Components For A Single Axle Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Are 1/2-20 Lug Nuts Able To Be Used On M12-1.5" Wheel Studs?
- Q&A: Slide Topper For 2021 Grand Design Reflection
- Q&A: Replacement Bearing and Seal Kit for 2004 Kendon Motorcycle Trailer
- Q&A: Dimension of Redline Bolt-On Spring Latch # SL716
- Q&A: Trailer Axle Weight Rating for 2 Inch Square Axle
- Article: Overview of Lubricating Grease
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Maintenance Schedule
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)