Solution for Gaining Ground Clearance on Trailer by Lifting Suspension
Question:
I need to know what I need to do my trailer the back drags on the slightest bump even unloaded but when I put it on a hitch then the front is to close to the ground and the Jack drags its a 6.5x12
asked by: Mathew
Expert Reply:
You always want to tow your trailer as level as possible so the best option to gain ground clearance would be to raise the suspension of the trailer.
You can do this by moving the axles from being above the leaf springs to below the leaf springs.
The diameter of your trailer axle will determine the size of the parts that you will need to order. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, # K71-385-00, would be a great choice and if your axle is 2-3/8 inch diameter you could use the Over-Under Kit, # K71-384-00. These kits can be installed without welding but the manufacturer strongly recommends having the new spring seat tacked in place on the other side of the trailer axle.
Some refer to this process as "flipping the axles," but since axle has a slight bow to it you can't just flip them and reinstall them under the springs using the same spring seats. You have to install new spring seats on the opposite side of the axle so that it can be moved below the spring.
Products Referenced in This Question
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Leaf Spring Suspension
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Recommended Suspension Enhancements for a 2022 Grand Design Imagine 2910BH
- Article: Slipper Spring Trailer Suspension System Review
- Article: Most Popular Wheel Bearings
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Q&A: Installation of Dexter Kit # K71-385-00
- Article: How to Accurately Measure Trailer Leaf Springs
- Q&A: Is it Possible to Raise Suspension of Trailer that Has Slipper Springs
- Q&A: Replacement Leaf Springs and Wet Bolt Kit For a 2007 Fleetwood Redline 33 Toyhauler
- Q&A: Replacement Leaf Springs For a 2007 Feetwood Redline 33 Toy Hauler Travel Trailer
- Q&A: Do Spring Seats Have to Be Welded to Install Axle Over Under Kit