Will There be Any Modification Needed to Install the Curt Front Hitch on a 2017 Ram 3500
Question:
Will I need any to make any modifications to my 2017 Ram Megacab SRW to install this front hitch receiver e.g. Air dam, etc?
asked by: CJ
0
Expert Reply:
When installing the Curt Front Mount Trailer Hitch Receiver, # C31067, the trimming of the front air dam may be required.
To get the hitch to fit under the bumper the air dam will most likely need to be trimmed to allow the receiver tube to set nice and flush up under the bumper.
If you click on the instructions link toward the bottom of the page you will be able to see the step by step instructions on how and where to trim the front air dam.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Does Curt Front Hitch # C31067 Fit 2014 Ram 3500
- Q&A: Curt vs Draw Tite Front Hitch for Motorcycle Carrier for 2017 Ram Megacab 3500
- Q&A: How Long Is the Warranty On An Electric Over Hydraulic Actuator for Disc Brakes
- Q&A: Will Using Front Mount Trailer Hitch On 2018 Ram 3500 For Bike Rack Block View
- Q&A: Bolt Hole Spacing of Demco DM16080-52 and Titan T4853100 21K Trailer Couplers
- Q&A: LED Trailer Taillight Recommendation for a 3110 Feather Lite Car Trailer
- Q&A: Converting From 7-Way Round to 7-Way Flat Connector
- Article: How to Mount a Truck Bed Camper
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Trailer Hitch Receiver Sizes
- Article: Best Bike Racks for Fat Bikes
- Article: Stability Control for Heavy Duty Vehicles
- Article: A Better Way to Find the Best Campgrounds in Each State
- Article: How Much Solar Power Do I Need For My RV?