7-Way Plug Recommendation for Replacing 4-Way of Hitch Light Fixture
Question:
I have a honda ridgeline 2011 with a 7 way blade connector. I bought a hitch mounted trailer light, right and left signal, break connected to a 4 pin flat connector. A white wire is connected to the unit which is for reverse light. Can I just cut the wires from the 4 pin and screw them into a Pollack 7 way adapter then connect the white cable to the center for reverse light? The wires on the 4 pin connector are really thin. Many thanks for your help and info.
asked by: Romy C
0
Expert Reply:
What you described is a very good idea.
You could just cut off the 4-way of the light and then wire it to the part # A7WCB and you'd be good to go.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
7-Way Round RV Style Trailer Connector - Trailer Side
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 7 Round - Blade
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Shop: 7-Way Round RV Style Trailer Connector - Trailer Side
- Shop: Fusion LED Combination Tail Light Bar for Trailers Over 80" Wide - Submersible - Red/Clear Lens
- Shop: Single Axle Trailer Fender for Enclosed Trailers - Steel - 15" to 16" Wheels - Qty 1
- Search Results: 1/2 20 lug nuts
- Video: Review of Peterson Trailer Lights - Clearance Lights - M181R
- Video: Optronics Trailer Lights - Tail Lights - STL264RB Review
- Video: Command Electronics Trailer Lights - Clearance Lights - 328-003-183RR Review
- Video: Optronics Trailer Lights - Clearance Lights - MCL111RKB Review
- Shop: Loctite Bulb, Lamp, and Electrical Connection Dielectric Grease - 0.33-Oz Tube
- Shop: Dielectric Grease for Electrical Connectors, 2 oz.
- Shop: Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 14-7/8" Travel - 2K
- Shop: GloLight Uni-Lite Mini LED Clearance or Side Marker Light with Grommet - Round - Red Lens
- Q&A: How to Connect two 12 Volt Batteries and Still have 12 Volts Output
- Video: Review of Optronics Trailer Lights - LED Clearance/Side Marker Light - MCL110RKBF
- Video: Optronics GloLight Uni-Lite LED Clearance and Side Marker Light Review and Installation
- Video: Peterson LumenX LED Trailer Tail Light with Grommet and Plug Review and Installation
- Search Results: lug nuts
- Search Results: wire grommet
- Q&A: Wiring Diagram to Replace HD 7-Way with Standard Blade 7-Way
- Q&A: Why is There a Wire Color Differnce Between 7 Way Traditional vs RV Standard
- Search Results: air force one
- Q&A: Wiring Diagram for the Adapter 6-Pole to 7-Pole Trailer Wiring Adapter # 47435
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Fifth Wheel Hitch For 2001 Ford F-350 With Gooseneck Hitch In Bed
- Q&A: 2013 Ford F-150 With Factory Brake Controller Will Not Recgonize that the Trailer is Connected
- Q&A: Installing a 7-Way Trailer Connector on a Trailer with 6 Wires
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV