Installing a Hopkins Brake Controller on a 2014 Nissan Frontier Without the Factory Tow Package
Question:
..i have a Hopkins controller..nissan colors are lt green ,yellow,brown,black and red..how do I match up for hard wire 2014 Nissan Frontier
asked by: Jeannie R
Helpful Expert Reply:
Since the colors of wiring can vary on different vehicles, the best way to ensure that you have correctly installed your Hopkins brake controller, like the Agility # HM47295, is to use a Circuit Tester # PTW2992 to see what each of the functions on your wires are. You will then want to connect the wires on the pigtail of the Agility to the following functions:
Black - 12V Power
Blue - Brake Signal to 7-Way Connector
White - Ground
Red - Stop Light Switch (only gets hot when the brake pedal is pressed)
If you have 5 wires then the 5th wire will just need to be disregarded.
If you do not already have a 7-Way installed on your 2014 Nissan Frontier then you will want to also install the Tekonsha T-One # 118266 which includes the relays needed to activate the tow package. If you already have a 7-Way then you will want to check your fuse box to make sure that the relays are already installed. If they are not, and the relay locations have metal pins then you can use the Curt Relay Kit # C57000. Some Nissan vehicles may require a 3rd Relay, one of the blue relays from the # C57000 relay kit.
I have attached some installation videos for the T-One and Relays that you can use as a reference.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package
- Accessories and Parts
- Trailer Wiring
- Relays
- CURT
more information >