Fitting Size and Thread Pitch for Redline Wheel Cylinder BP17-030
Question:
what is the threading on the connection to the 3/16 brake fluid line. when i tried to make a connection with what exists on my trailer, it binds up. Is it metric threading?
asked by: Dale O
0
Expert Reply:
On Redline Wheel Cylinder # BP17-030 the brake line fitting is standardized, 3/8-inch with 24-TPI (24-threads per inch). I confirmed with my contact at Redneck.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Wheel Cylinder - 10" and 12" Single Serve LH
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- Wheel Cylinder
- 10 Inch
- 12 Inch
- Uni-Servo
- Redline
more information >
Continue Researching
- Q&A: Trailer Hub Recommendation to Replace Dexter 8-155
- Q&A: Comparing 77-1210-2 and 23-450/23-451 Trailer Braking Assemblies
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Q&A: How to Determine Needed Pilot Diameter of Steel Dual Trailer Wheel
- Q&A: What is Trailer Wheel Pilot Diameter
- Q&A: Replacement Seal Recommendation for Dexter 010-004-00
- Q&A: Replacement Hub & Drum For UFP HD-1377-10 & Hydraulic Brakes For Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: 2023 Best Gifts for RVers & Campers
- Article: 2023 Best Gifts for Auto Enthusiasts
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Adding Electric Over Hydraulic Disc Brakes