Which Trailer Brake Magnet is the Ground Wire and Which is the Power Wire
Question:
I am getting groud on both wires coming out of the backing plate all the time. I can not feed the magnets power if I am getting groud all the time. What is causing this? Everything is new from controller to wires to backing plates
asked by: Paul C
0
Expert Reply:
Trailer brake magnets are not polarity specific which means that either wire can be the power or ground wire. So basically you get to pick which of the two wires you want to be the ground or the power wire.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Power On the Ground Wires Going to the Brake Magnets
- Article: Most Popular Wheel Bearings
- Article: Trailer Wiring Diagrams
- Q&A: What is Difference Between Dexter Hubs # # 8-201-9UC3-EZ and # 8-201-5UC3-EZ
- Q&A: Troubleshooting A Noisey Coleman-Mach RV Air Conditioner
- Q&A: Difference Between Dexter Hub and Drums 42866UC3 & 42866UC3-EZ
- Q&A: Will MORryde Upgraded HD Shackle Kit Fit 2020 Grand Design 2670MK
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Converting Trailer from Surge Brakes to Electric Brakes
- Q&A: Correct Replacement Braking Assemblies and Hubs for a 2009 Airstream PanAmerica
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Replacement Automotive Lighting
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers