Video Guide to Use for Assembly of Trailer Hub and Install on Axle
Question:
Do you have an assembly video and or all the parts that go in a dexter 8-248 wheel hub? Somebody took this apart and Im not positive the parts needed and how to put back together. Thank you,
asked by: Shawn W
0
Expert Reply:
I do have an install video (linked below), that shows a hub getting installed similar to the # 84545BX that you have but the first thing you'll need is a new grease seal since when you disassemble a hub you end up destroying the seal.
For that you'll need the part # 58846.
expert reply by:
Jameson C
0
Products Referenced in This Question
Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Double Lip
- 1.719 Inch I.D.
- 2.565 Inch O.D.
- etrailer
more information >
Product Page this Question was Asked From
Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2
- Trailer Hubs and Drums
- Hub
- Standard
- L68149
- L44649
- For 3500 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 13 Inch Wheel
- 14 Inch Wheel
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- 16-1/2 Inch Wheel
- Dexter
more information >
Continue Researching
- Q&A: How to Read the Lippert Components Axle Description Measurements
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: Trailer Wiring Diagrams
- Article: How to Charge a Dump Trailer Battery
- Q&A: Replacement Trailer Hub Assembly for Dexter 8-248 Hubs
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Maintenance Schedule
- Article: Most Popular Wheel Bearings
- Q&A: Should I Buy a Horse Trailer with Torsion Axles or Straight Axles with Leaf Springs
- Q&A: Raising Trailer with Welded On Torsion Axles
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Distance From Hitch Pin Hole to Gusset on Curt Ball Mount C45112
- Article: Roadmaster Vehicle Specific Base Plates