Where Weld On Receivers are Measured From
Question:
On the 41990-07 and -16 is the height measured from the top of the weld on bracket to the top of the receiver or to the bottom of the receiver?
asked by: Steve B
0
Expert Reply:
The dimensions are measured from the top of the brackets to the bottom of the receiver; Draw-Tite # 41990-07 will offer 7" of drop, while Draw-Tite # 41990-16 is going to give you 16 inches of drop.
expert reply by:
Kyle S
0
Products Referenced in This Question
Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 16 Inch Drop
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Ultra Frame Service Body Trailer Hitch Receiver - Weld On - Class V - 2"
- Heavy Duty Receiver Hitch
- Weld-On
- 44 Inch Wide
- 1600 lbs TW
- 16000 lbs GTW
- Class V
- 2 Inch Hitch
- 7 Inch Drop
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Class V Hitch For A 2020 Ford F53 Chassis
- Q&A: Universal Hitch to Install on a Class A RV Rated for 10,000 Pounds
- Q&A: Recommended Trailer Hitch for an International 3800 School Bus
- Q&A: Trailer Hitch for 2010 IC Bus CE-Series
- Q&A: Recommended Trailer Hitch For 2014 GMC Savana Cutaway Chassis
- Q&A: Recommended 10K Trailer Hitch for Ford F-53 Chassis
- Q&A: How Far Out Will Curt 15400 Extend on 2023 Ram 3500 Cab and Chassis
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: My Trailer Hitch Doesn't Fit
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)