How to Wire the Gustafson RV Vanity Light Part # 277-000324

Question:

wired up to switch but want come on..checked wires coming out with switch on has power. no instruction with product.. 2 white wires coming off each of the 3 lights

asked by: Kelly G

Expert Reply:

In order to wire the Gustafson RV Vanity Light part # 277-000324 to an electrical switch on an RV you will first want to obtain a few items: wire stripers, wire nuts, and electrical tape. Once you have these three items you can begin to install the vanity lights.

There are two wires coming from the back of each light on this vanity light for a total of 6 wires. One is for the ground and the other is for the power. You will want to begin by attaching one wire from each light to one another. It doesn't matter which wire you choose as they are not polarity specific. You can use the wire strippers to remove a 1/4" off each wire. You can then place the ends of the wires into the wire nuts and twist them clockwise to secure the connection. Once the wire nuts have been tightened you will want to use a bit of electrical tape to fully encase the wire nut. You can run one set of three wires to the ground terminal on the RV's light switch. The other set of three wires will need to be ran to power circuit of the RV's light switch.

expert reply by: Conner L