Replacement 4-Way Solution for Trailer that Has 2 Wires Ran to Each 4-Way Pin
Question:
My jet ski trailer has a Wesbar 4 prong connector that has 8 wires coming out of it. i would like to buy a a replacement plug i could splice into the wires. all i can find on your site is 4 prong with 4 wires. cand you help me?
asked by: Rick G
0
Expert Reply:
Sounds like your 4-way has two wires ran for each pin. This can be wired to a 4-way that has a single wire for each pin. You would just have to run the pair of wires for each circuit to the single wire of the new 4-way.
The part # 002220 that you referenced could work but it would be a bit long at 20 feet. You would just need to cut down the length of the wires.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Wesbar 4-Way Flat Trailer Wiring Harness - 20' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 11 - 20 Feet Long
- Plug and Lead
- 4 Flat
- Wesbar
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Adding Crossbars To A Teardrop Trailer
- Q&A: Is The 1/2" Metal Loom Clamp # A0500 a Single Component Or Multiple Clamps?
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Q&A: How Many Leaves are on 3,500 lb Trailer Axle Leaf Springs
- Q&A: What Diameter is a Dexter 4,000 lb Axle
- Q&A: How to Determine Correct Replacement Axle for Trailer
- Q&A: Heavy Duty Dexter Suspension Kit For 2011 Dutchman Denali Trailer
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs