Solution for Broken Bulldog A-Frame Jack
Question:
Found out the metal snapped. Solution?
asked by: Christopher W
0
Expert Reply:
Did you possible over extend the jack? If you let the jack over extend you will destroy the threads of the screw of the and nut which will prevent the jack from being able to go up or down.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stromberg Carlson Electric Trailer Jack - Drop Leg - A-Frame - 23" Lift - 5,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Leveling Jacks
- Tongue Jack
- Steel
- 4001 - 5000 lbs
- Electric Jack
- 23 Inch Lift
- Bolt-On
- 1 Jack
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Trailer Wiring Harness Recommendation for a 1999 Isuzu NPR
- Article: Trailer Wiring Diagrams
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Hub And Drum Replacement for 90865 Rockwell Hub and Drum
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Components for Off-Road Trailer Similar to Chevy Colorado Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Slide Topper Recommendation for Box Width of 90.5 Inches on Gulf Stream Vintage 23BHS
- Article: How to Choose the Right Trailer Hitch Class
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
Christopher
8/31/2017
Found out the metal snapped. Solution?