How to Pick Out Install Hardware for Plunger and Rubber Socket Door Holder # PLR62-66
Question:
I just received the PLR62-66 plunger and rubber socket for my trailer. What bolts or screws are recommended for installation? Thanks.
asked by: Jon D
0
Expert Reply:
Really it depends on your application. Best option would be to check out where you want to install the plunger kit and decide if wood screws or nut and bolt would work best. Once you make that decision consider the depth you'll need and then take the plunger with you to the hardware store to find the correct length and style bolts that will fit in the mounting holes.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Plunger and Socket Trailer Door Holder - 1-3/4" Plunger - Zinc Plated Steel
- Trailer Door Holders
- Plunger and Socket
- 1-3/4 Inch Plunger
- 2-1/2 Inch Hole Spacing
- Rubber
- Polar Hardware
more information >
Continue Researching
- Q&A: Replacement Propane Tank Cover For A 2005 Trail Lite Hybrid Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: How to Wire the ThermaHeat RV Holding Tank Heater Pad To an On/Off Switch
- Q&A: Can Different Hole be Drilled into Suspension Rear Hanger
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Door Latch for 1995 Kiefer Built Golden Eagle Horse Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Mounting Hole Spacing of Parts in Plunger and Rubber Socket Door Holder PLR62-66
- Q&A: Replacement RV Power Converter for Parallax 7345
- Q&A: Door Retainer Stronger Than Rubber Door Retainer
- Article: How to Mount a Truck Bed Camper
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Troubleshooting Brake Controller Installations
- Article: What Exactly is Tongue Weight?