What Circuit Does Brake Controller Stoplight Wire Run to on 2016 Toyota RAV4
Question:
I have a 2016 Rav4 SE AWD. I am going to be installing a trailer brake controller on it. I was able to get a schematic of the stop light wiring system for the car. I am wondering which would be the cold side of the switch, there are 2 wires on one connection, and only one on the other. My friend from work said I should connect it to the ground. Is this correct? Thanks
asked by: Mat
0
Expert Reply:
You want to connect the red wire of your brake controller to the circuit that sees voltage only when the brakes are applied. That would not be a circuit that runs to a ground.
Test the wires with a circuit tester if you are unsure like the part # 3808 and you'll find it that way.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Article: Determining Trailer Tongue Weight