How to Tap Into 3rd Brake Light Wire on 2005 GMC Sierra
Question:
is there a male connector and wire to plug into the female connector on that light blue wire for the 3rd break light
asked by: John
0
Expert Reply:
We do not have OEM type vehicle wiring connectors but you can make a spliced connection to your 2005 Sierra's 3rd brake light wire using a Quick-Splice connector such as # SWC501915-1. These allow you to tap into that vehicle wire's brake light switch signal which is sometimes required for hardwired brake controller installations.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Quick Splices - Self-Stripping Connector - Closed Port - 10-12 Gauge - Yellow - Qty 1
- Wiring
- Wire Connectors
- Quick Splice Connectors
- 12-10 Gauge
- Spectro
more information >
Continue Researching
- Q&A: Why Does Trailer Wiring for 2017 Toyota Sienna Require Running Wire to Vehicle Battery
- Q&A: Left Hand Vs. Right Hand Placement of Ramp Springs on a Trailer Ramp
- Q&A: How to Wire Electric Trailer Brake Magnets to 12 Volt Brake Output and Ground
- Article: Trailer Wiring Diagrams
- Q&A: How Much Voltage Is On Cold Side Wire Of Vehicle Stop Light Switch?
- Q&A: How to Wire Electric Brakes on a Tandem Axle Trailer
- Q&A: Removing Stuck Blue Ox Gooseneck Hitch Ball BX62-3604
- Q&A: Wiring Brakes On Tandem Axle Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure a Trailer Axle
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation: Starting from Scratch