Where are the Fill Ports on the Valterra RV Water Tank # R8036
Question:
How do you VENT the Valterra RV Water Tank Part #R8036 and FILL it?
asked by: Nathan
0
Expert Reply:
There are 6 total ports that are on the Valterra RV Water Tank # R8036. The drain at the bottom is already drilled out and ready to be used. To install a fill port you would need to punch out the upper ports which are still sealed.
I attached a picture that points out the ports for you to see where they are.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Valterra RV Water Tank - Non-Toxic - ABS Plastic - 36" x 8" x 16" - 18 Gallons
- RV Fresh Water Tank
- 11 - 20 Gallon Tanks
- 3/8 Inch Fittings
- 31 - 40 Inch Long
- 11 - 20 Inch Tall
- 0 - 10 Inch Wide
- Black
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Correct Replacement Complete Awning to Replace a Dometic 9100 Basement Awning
- Q&A: How to Wire Solera Smart Arm 12V Power RV Awning
- Q&A: Towing Capacity of 2015 Chevy Silverado 1500 Crew Cab 4x4 with 5.3-liter V8 Engine
- Q&A: Shipping Weight of Dexter Trailer Axle T20BTR-EZ-7258
- Q&A: Can Valterra RV Water Tank be Installed Vertically or Horizontally
- Q&A: Why You Can't Use An Electric Pump With The Valterra RV Tank?
- Q&A: Valterra RV Fresh Water Tank R8036
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: Which RV Propane Tank Size Do I Need?