Install Hole Diameter for the D-Rings part # RR09
Question:
What type of bolt / hardware do you recommend using for mounting the base and for the actual d ring? Thank you
asked by: Dan B
0
Expert Reply:
The diameter of the install holes of the D-ring part # RR09 are 1/4 inch. Best option would be to use hardware that matches that diameter that also matches the material you want to install the ring to on your trailer.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy Rope Ring Tie-Down Anchor with Plastic Pan - Bolt-On - Surface Mount - 1,000 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1000 lbs
- D-Ring
- Surface Mount - Bolt-On
- Brophy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Activating 12-Volt Accessory Circuit to 7-Way on 2004 Chevy Silverado 2500
- Q&A: Fuse Location for 12-Volt Accessory Feed to 7-Way Trailer Connector on 2005 Chevy Silverado
- Q&A: Where to Locate the Factory Brake Controller Plug in a 2022 Ford Explorer with Factory 7-way
- Q&A: Fully Extended Height Of The Ark Drop Down Croner RV Stabilizer Jacks
- Q&A: Dimensions of ARK DDS750 RV Stabilizer Jack Mounting Plates
- Q&A: Stabilizer Jack Recommendation for 4 Corners of Hi-Lo Travel Trailer
- Q&A: Replacement Dexter Brake Assemblies for 36-19 Assemblies
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Tire Sizing
- Article: Trailer Wiring Diagrams
- Article: Boat Trailer Showdown: Bunks vs. Rollers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The 5 Best Trailer Drop Hitches You Can Buy