Pick Out Powered Landing Gear for 2008 Fuzion 393 Toyhauler
Question:
Need to replace the landing gear on our 2008 Fuzion 393 Toyhauler. Dry weight on 5th wheel is 13,140lbs - its a heavy trailer. Current system is single motor electric and has failed more than once - looking to replace with dual motor heavy duty landing gear. Also from looks of things I will have to remove the generator to get to one side of landing gear. Which system would best fit our needs and trailer: Bulldog or the Ultra Fab UF17-943010.
asked by: Denise B
Helpful Expert Reply:
In order to pick out a direct replacement for the landing gear on your 2008 Fuzion 393 we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Reese/Bulldog Tandem Landing Gear Set # RP500708. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed.
I attached a picture that shows the dimensions that this landing gear set would fit with.
The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.
If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.
Products Referenced in This Question
Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs
- Camper Jacks
- Fifth Wheel Camper
- Leveling Jacks
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- Landing Gear
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 5,500 lbs
- Shop: Bulldog Tandem Landing Gear Set - Drop Leg - 36" Lift - 8,000 lbs
- Shop: Stromberg Carlson Electric Landing Gear Set - Weld On - 34-7/8" Lift - 6,500 lbs
- Shop: Lippert Electric Landing Gear Set - Weld On - 37" Lift - 6,000 lbs
- Video: Stromberg Carlson Trailer Jack LG-179014 Review
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Shop: Replacement Follow Jack w/ Drop Leg for Stromberg Carlson Landing Gear - 29-1/2"
- Shop: Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs
- Search Results: bd185400
- Search Results: bulldog jack motor
- Video: Lippert Components Trailer Jack LC178652 Review
- Search Results: fifth wheel landing gear
- Search Results: spring loaded pull pin
- Q&A: Landing Gear Recommendation for a Heavy Toy Hauler Fifth Wheel
- Shop: Fifth Wheel Hitch
- Shop: RV Jack Pads
- Shop: RV Roof Membrane
- Shop: RV Camera
- Shop: RV Covers
- Q&A: Selecting Replacement 5th Wheel Landing Gear for 2008 Keystone Fuzion Toy Hauler
- Video: Lippert Ground Control Electric Leveling System Installation - 2015 Forest River Vengeance TT Toy Ha
- Q&A: Recommended Wiring For Tow Dolly And Vehicle Lights For Towing Behind Motorhome
- Q&A: Fresh Water Pump to Replace Shurflo 2088-422-144