Overall Side To Side Dimensions Of Flexco Manual Pull-Out Steps
Question:
Confused - the diagram with dimensions on the product page RV-and-Camper-Steps/Stromberg-Carlson/SMFP-2100l says the overall width is 27 5/8 but in the video it measures as 26 1/8 and I think its 26 when someone asked a question here:could you please clarify? Thanks
asked by: Paul P
Expert Reply:
The problem is that the overall measurement at 27-5/8 inches is from the end of the rod that extends out on both sides. The 26-1/8 inches is the dimension of the mounting brackets at the top of the steps.
I have attached a photo with dimension noted of the Flexco Manual Pull-Out Steps # SMFP-2100 you can check out.
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Double - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 27-5/8 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Step Compatible with 2016 R-Pod Trailer for Low Rise
- Q&A: Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Dimensions for the 10K Demco eZ-Latch A-Frame Trailer Coupler
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Q&A: Which Torklift StableLoads fit 2019 Ford F-350
- Q&A: Towing Capacity of a 2014 Ford F-150 4x4 with 5.0 Liter Motor
- Q&A: Wiring Instructions For The Furrion Automatic Transfer Switch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Must Have RV Accessories that Will Make or Break Your Trip
- Article: Top 10 Upgrades for Your Camper
- Article: How to Install an RV Awning From Scratch