Would Toggle Switch # PK34218 Be Rated to Turn On Winch
Question:
Will this toggle switch be sufficient to carry the amps for a winch on a Star Craft pop up using a 12 volt marine battery my toggle switch is failing when i raise or lower my pop up thanks.
asked by: Lassie
1
Helpful Expert Reply:
I wish I could say yes, but winches can sometimes draw a considerable amount of amperage and this switch is only rated for 50 amps. Some winches can draw up to 200 amps.
What you can do is check the amperage draw rating for your winch and if it happens to be under 50 this # PK34218 would work.
expert reply by:
Jameson C
1
![Jameson C](https://images.etrailer.com/static/images/catg/people/371_tn.jpg)
Product Page this Question was Asked From
Pollak Heavy-Duty Toggle Switch - SPDT- On-Off-On - 12 Volt - 50 Amp - 1" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- 50 Amp
- Pollak
more information >
Continue Researching
- Q&A: Diode for Preventing Trailer 12 Volt Accessory Circuit From Backfeeding
- Q&A: I A Latch For My RV Door That Has A 4-1/2 inch X 4-1/2 inch Hole
- Q&A: Does the Ventline Exterior Wall Vent for RV Range Hood # V2018-01 Have a Screen
- Q&A: Recommended Replacement Grease Seal for 2014 Shorelander Boat Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Correctly Position Ramp Door Spring for Installation
- Q&A: Replacing Peterson PM130 Incandescent Trailer Lights with LED Versions
- Q&A: Adding an In Line Fuse to a 12 V Power Lead from a Vehicle Battery to a Trailer Connector
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: How to Wire an Electric Winch
- Article: Trailer Wiring Diagrams