Can Edge CS2 Programmer be Unplugged from Vehicle Once Programming is Completed
Question:
I have a 2010 gmc sierra with the edge evolution cs2 on it. After i set the program in it that i want will it be safe to unplug the programmer ? And will the setting stay in the truck with it out?
asked by: Brian L
0
Expert Reply:
Yes, once the programming is complete with the Edge CS2 part # EP85350 that you have you can unplug it from the vehicle and it will run just fine and the tune stays on the vehicle. You only lose the monitor features when you do this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Edge Gas Evolution CS2 Performance Tuner- Color Screen
- Performance Chip
- Performance Tuners
- Tuner Only
- Color Screen
- No - Not California Approved
- Evolution
- Edge
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Thule Hullavator Pro TH898 - What Are The 35mm and 37mm Bolts For?
- Q&A: Will the Edge CTSV2 Work with my 2008 GMC Sierra 2500 with the 6.0L Gas Engine
- Article: Performance Chips and Modules
- Article: Trailer Tire Sizing
- Q&A: How To Use Rope With The Tie-Down Cleat for TracRac Ladder Racks
- Q&A: How to Increase Towing Power in 2003 Chevrolet Avalanche 1500 with 5.3L V8 Towing 7600-lb Trailer
- Q&A: Trailer Hitch Recommendation for 2022 Subaru Forester Wilderness Edition
- Q&A: Power Awning Conversion Kit for Carefree Fiesta BN3N4
- Q&A: Why Must the Negative Battery Cable Be Disconnected on a Jeep Wrangler to Flat Tow
- Article: RV Cell Boosters, How Do They Work?
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Types of Bumpers