What are the Measurements for the Pin in the Replacement Spring Bar Retaining Pins and Clips HT32335
Question:
What are the measurements for the pin? The one I have is 2-7/8inch long and 3/8inch wide. Also, do you have just the thumb clips available?
asked by: Mark H
Expert Reply:
The Replacement Spring Bar Retaining Pins with Thumb Clips for Husky Weight Distribution Systems # HT32335 will replace the pin and thumb clips from the following Weight Distribution (WD) systems by Husky:
Parts # HT32215, # HT32216, # HT32217, or # HT32218.
If you have any of these WD systems then the clips are confirmed to fit.
I contacted the manufacturer and they don't have the technical information on the pin and thumb clips, but my contact did say that they only come in a set so you we do not have just the thumb clips available.
