Can B&W Biker Bar BWMC2302 Be Installed in Truck Bed
Question:
Can your Biker Bar be used in a pickup bed? Yeah I know it might be tough to do because of the difficulty of getting to things under the truck but what Im really concerned about is, THE thing I want to know is, is the floor of the pickup bed strong enough to take the torque load that would be placed on it or would it ultimately tear it up?
asked by: Chris G
Helpful Expert Reply:
The corrugated sheet metal of a truck bed does not have the strength to allow safe installation of a motorcycle transport system like the Blue Ox Bike Bars setups # BWMC2302, # BWMC2301 and # BWMC2300.
In order to mount one of these carriers systems to a pickup's bed you would need to provide reinforcement to the bed. You could have a steel plate welded to the truck's frame, under the bed, to which the Biker Bar could then mount. This would likely require alternate hardware to reach down to this plate.
My contact at B&W did indicate that they have had customers successfully install the Biker Bar in their beds using only 3/4-inch plywood on top of the bed as a means to distribute the load and to reinforce the bed.
Between these two methods I would certainly recommend going with a welded steel plate over the plywood but that does remain an option which B&W considers adequate.
Products Referenced in This Question
B&W Biker Bar Motorcycle Tie-Down System Base with Anchor Plates
- Accessories and Parts
- Motorcycle Tie Down Straps
- Tie Down Anchors
- Motorcycle Anchor Parts
- Bases
- B and W
more information >
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Touring
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Product Page this Question was Asked From
B&W Biker Bar Motorcycle Tie-Down System for Trailers - Harley-Davidson Softail, Dyna, V-Rod
- Motorcycle Tie Down Straps
- Trailer
- Clamps
- Tie Down Anchors
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Cover for a 7 x 14 V-Nose Enclosed Trailer
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Q&A: What is The Height Of The CargoBuckle Ladder Rack Straps From Bolt Base To Bottom of Hook Opening.
- Q&A: What Is the Difference Between Biker Bar # BWMC2302B and # BWMC2301B?
- Q&A: B&W Biker Bar Motorcycle Tie-Down System Parts Needed For a Harley Davidson Dyna
- Q&A: Is Bushing Required on Open Eye End of Slipper Spring
- Q&A: Does Karavan KHD-2990-72-12 have Trailer Brakes
- Q&A: Installation if EcoHitch 306-X7196 on 2008 Toyota Prius
- Article: My Trailer Hitch Doesn't Fit
- Article: Best Bike Racks for Electric Bikes
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: Which Hitches are Made in the USA
- Article: Roof Rack Information
- Article: Sidewinder with Rotating Turret for Short Bed Pickups