Replacement Manual Pull-Out Steps for a 2011 Four Winds Breeze Travel Trailer
Question:
Do you mind if I ask for your assistance, When I measure the distance width between the top mounting holes, I get pretty close to 25 1/2inch center to center. Will either of these steps work and which one would you recommend if so. I am replacing the factory 24inch two step system for a 24foot Four Winds Breeze pull trailer 2011. I like the idea of the 350 lb one as a friend of ours was too heavy for the steps we have, but will use which ever you think will work best. Would sure appreciate your in-put! Thank you, Terri Flexco Manual Pull-Out Steps for RVs - Double - 7-7/8inch Drop/Rise - 24inch Wide - 350 lbs Item # SMFP-2100 Lippert Manual Pull-Out Step for RVs - Double - 7inch Drop/Rise - 24inch Wide - Steel - 300 lbs Item # LC432682
asked by: Terri M
Expert Reply:
Looking at the picture of your existing steps it appears they are attached on the sides rather than at the top of the steps. If that is the case then Lippert steps # LC432682 could work because the overall width of these steps is 25-1/4 inches. So they can bolt up in place of the ones you have.
Step set # SMFP-2100 would be too wide for this.
![Michael H](https://images.etrailer.com/static/images/catg/people/324_tn.jpg)
Products Referenced in This Question
Flexco Manual Pull-Out Steps for RVs - Double - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 27-5/8 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Product Page this Question was Asked From
Lippert Manual Pull-Out Step for RVs - Double - 7" Drop - 24-1/4" Wide - Steel - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25-1/2 Inch Wide
- 2 Steps
- 7 Inch Drop/Rise
- No Ground Contact
- Steel
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Angle of Different Stabilizer Positions for Ark Drop Down Corner RV Stabilizer Jacks
- Q&A: Dimensions for the 10K Demco eZ-Latch A-Frame Trailer Coupler
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: Replacement Step Compatible with 2016 R-Pod Trailer for Low Rise
- Q&A: Recommended Replacement Stabilizer Jacks For A 2011 K-Z Durango 1500
- Q&A: Dimensions of Weld-On Plate for Ark Drop Down Corner RV Stabilizer Jack Kit
- Q&A: Overall Length of the 24" and 30" Ark Drop Down Corner Stabilizer Jacks
- Article: How to Measure for Motorhome Steps
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: Trailer Lighting Requirements