Replacement Fulton Jack for Ranger Boat Trailer

Question:

Have current jack FTJinch 1200# that came with ranger boat in 1998...it died ...want to to replace with same jack with same hole dimensions as it is a welded bracket. The holes need to be 3inch x 5 1/2....can you tell me if this is still the same hole dimensions for ftj120W0301? Thank you!

asked by: Stan R

Expert Reply:

If your original Fulton jack is a snap-ring type swivel jack that uses the same 2.313-inch pilot hole diameter then Fulton 1200-lb jack # FTJ120W0301 should do the trick. You may not even need to bother with welding on the (included) new mounting plate.

I went to our warehouse and measured the diameter of the 4 holes - they are 3/8-inch - and their spacing. The hole centers are spaced 3-inches apart.

You can refer to the linked page that will show you all 1200-lb frame-mount jacks, both fixed-mount and pull-pin types.

expert reply by: Adam R