Hitch Ball Recommendation with 2 inch Diameter and 3/4 inch Shank
Question:
I need a 2inch ball with a 3/4inch threaded post rather than the normal 1inch threaded stem. I need it because I cant use the stem extension they sold me with the car because it is so long it makes my trailer shimmy. It must fit into my normal length subaru trailer stem which goes into a 1x1inch port and has a 3/4inch hole for the ball threaded stem.
asked by: Todd A
1
Helpful Expert Reply:
For a 2 inch hitch ball that has a 3/4 inch threaded shank you'd want the part # 19258. I attached a review video for this ball for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Parts Needed to Add Brake Controller to 2024 Toyota Sienna Platinum
- Q&A: Can A Class III Ball Mount Be Used On a Class II Hitch
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: Parts Needed to Install 7-Way and Brake Controller 2024 Toyota Grand Highlander
- Q&A: Picture of Trailer Hitch Installed on a 2016 Mazda CX-3
- Q&A: Trailer Hitch Receiver & Towing Set Up For Lexus 2006 IS 250