Troubleshooting WirelessONE Replacement Remote for Air Helper Springs

Question:

Just got a new remote and it won't work Reyes to sync it but still wont work any tricks to doing it?

asked by: Steve

Expert Reply:

There aren't necessarily any tricks to getting the Replacement Remote for Air Lift WirelessONE Compressor System, # AL72704, but according to the Air Lift Installation Guide, this is what you'll need to do.

1. Turn ignition on.
2. Locate the sync wire in the wire harness.It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver. Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second. This will indicate that you are now in the sync mode. Sync mode will last for 30 seconds total. Within the 30 seconds press any button on the transmitter to send a message to the receiver. Once the receiver has received a message it will sync with that transmitter and stop
clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.

If you do follow these steps and are still having issues, please let me know what the problem is and I'll be happy to help you.