Can Built-In Camber be Adjusted on Timbren Axle-Less Trailer Suspension System with Hubs
Question:
Can the caster be adjusted for toe-in etc as they wear?
asked by: Chris
Expert Reply:
When installing the Timbren Axle-Less Trailer Suspension System with Hubs # A12WS545 referenced in your question, the toe-in will need to be set. However, the system does include shims that will allow you to adjust the camber as needed. I have attached an installation video on this product for you to check out. Right around the 4 minute mark you can see this feature explained.
This is a great axle-less suspension system with a weight capacity of 1,200 pounds and a bolt pattern of 5 on 4-1/2 inches. The hubs will include the # L44610 inner and outer bearings, as well as the races and seals.
Products Referenced in This Question
Replacement Race for L44643 and L44649 Bearings
- Trailer Bearings Races Seals Caps
- Races
- Standard Races
- 1.980 Inch O.D.
- Bearing L44643
- Bearing L44649
- Race L44610
- 2000 lbs Axle
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Shop: 2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Shop: 7-Way Molded Trailer Wire Connector, 4' Long
- Search Results: 63845
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Westlake ST235/75R15 Radial Off-Road Trailer Tire - Load Range D
- Search Results: 63847
- Shop: RV Roof Membrane
- Shop: LaSalle Bristol XTRM Universal Self-Leveling Sealant - White - 10.1 oz - Qty 1
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - Smoke
- Q&A: Do the Timbren Axle Less Systems Have a Camber When Installed
- Shop: Battery to Fuse Holder Cable for Redarc MIDI Fuse Kit
- Video: Optronics Trailer Lights A68SSB Review
- Search Results: pf213246
- Search Results: plug
- Search Results: 7~pin plug
- Search Results: h20042
- Shop: 7-Way Round RV Style Trailer Connector - Trailer Side
- Q&A: Can You Align the Timbren Axle-Less Systems
- Search Results: smoke alarm
- Shop: Roof Rack
- Video: Rebuilding a Fulton Jack
- Video: Hopkins Trailer Breakaway Kit - Kit with Charger - 20099 Review
- Video: Draw-Tite Hitch Fabrication Parts - Receiver Tube - 2852 Review
- Q&A: What All Do I Need To Use The Lock and Roll Hitch System?
- Article: How to Measure a Trailer Axle
- Q&A: Can a Trailer Spare Tire be Slightly Smaller in Diameter than the Rest of the Tires
- Q&A: Replacement Grease Seal for the Timbren Axle Less System part # A12WS545
- Video: Review of Lock N Roll Ball Mounts - Articulating Ball Mount - 336VS501
- Q&A: Do You Need To Make Adjustments For Camber After You Install Timbren Axleless Trailer Suspensions
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)