Clearance Light Recommendation for 2-1/2 inch Hole In Flat Bed Truck
Question:
I have recently purchased a flat bed for my truck. It has 2.5 holes already drilled for the marker lights. Do you have any marker lights that will fit those holes? I was considering using flush mount lights with a flange.
asked by: Kevin K
1
Helpful Expert Reply:
We have 2-1/2 inch clearance lights but they require a 3 inch hole for the grommet like part # A55GB to install. For that you'd want the part # MCL51RB.
The next size down is 2 inch but the hole required is 2-5/16 inch which wouldn't work for you.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Rubber Grommet for 2-1/2" Round Trailer Lights - Flush Mount - Open Back
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 2-1/2 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Continue Researching
- Q&A: Correct Replacement for Dexter 010-036-00 Grease Seal
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: 2023 Holiday Must Haves
- Q&A: Benefits of Changing Trailer Tires to Higher Load Range
- Q&A: Benefits of Switching to Trailer Tires with Higher Load Range and Speed Ratings
- Q&A: Comparing Trailer Wiring Junction Box 3375601100 and Trailer Wiring Junction Box 38656
- Q&A: Retracted Height Dimension of the Bulldog Jack part # BD190708
- Q&A: Direct Replacement Oval Stop Turn and Tail Light for a Model J-60 Trialer Light is the # ST70RB
- Q&A: How to Cut a Grommet Hole for Installation of the Oval Trailer Tail Lights # STL22RB
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Where to Position the Trailer Axle?