Replacement Snap-Ring Trailer Jack that Uses Original Mounting Bracket
Question:
The original jack on our trailer is welded on. The pull pin is jacked no pun intended up and we need to replace it. I would like to re-use the mounting bracket that is in place. Will this one work for that purpose?
asked by: Gary B
Expert Reply:
To determine if the Fulton Round Snap-Ring Swivel Marine Jack # FTJ120W0301 will be compatible with the existing bracket on your trailer, you will just need to measure the diameter of the welded mount.
The inner diameter of the large mounting hole at the center of the Fulton Jack mounting bracket is 2-1/2 inches. This also uses a 3/8 inch size pull pin. Also note that this Jack includes a new weld-on bracket that can be used if you are not able to use the existing bracket.
If the sizes match up, then you will also just want to make sure that the 1,200 pound lift capacity on this unit is sufficient for your trailer.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement for Shelby Industries Model 5756 Boat jack
- Q&A: Can I Use Different Grease w/ the CE Smith Trailer Idler Hub Assembly?
- Article: Trailer Wiring Diagrams
- Q&A: Shelby Model # 5784 Trailer Jack Replacement Option
- Q&A: Jack Recommendation for Replacing Shelby Jack 5784
- Article: Most Popular Wheel Bearings
- Article: Best Boat Trailer Jacks
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Shelby Jack Model 5856A Replacement Recommendation on Jet Ski Trailer
- Q&A: Recommended Replacement for a Shelby Trailer Jack Model 5756
- Q&A: Correct Replacement for AL-KO 7230 Hub/Drum and Brakes
- Article: Trailer Lighting Requirements
- Article: Trailer Jacks