Will the Bulldog Top Wind Trailer Tongue Jack Work on a Carry-On Trailer
Question:
I need a replacement jack for my carry on trailer. Will the BullDog version fit? part# 155033?? I cannot find the model number of my Carry On Trailer.
asked by: Patrick H
0
Expert Reply:
Yes the Bulldog Round A-Frame Jack, # BD155033, will work well for your Carry-On model trailer.
The jack has a 2000 lbs lift capacity and a total of 15 inches of lift. The mounting bracket on the jack is usually an universal fit. To make your that this jack will fit, measure your current jack to see if the outer tube diameter is at least 2-1/4 inches. If your jack is not bigger than this measurement then the Bulldog jack will fit.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Bulldog
more information >
Continue Researching
- Q&A: Replacement Options For An American Enterprise CS-2000XL Power Converter
- Article: Trailer Wiring Diagrams
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Recommended A-Frame Jack with Most Ground Clearance
- Q&A: Does the Buyers Products Trailer Tongue Toolbox Come With Mounting Hardware
- Q&A: Recommendation for an A-Frame Jack with a Lower Retracted Height Than 8 Inches
- Article: Trailer Jacks
- Q&A: Can I Replace Leaf Springs With Lower Rating For Better Ride Quality
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: Trailer Lighting Requirements
- Article: Brake Controller Installation: Starting from Scratch
- Article: Double-Eye Trailer Suspension System Review
- Article: Top Weight Distribution Hitches for a Buttery Smooth Ride