Diameter of Air Vent on the Valterra City Water Inlet A01-2001VP
Question:
My Keystone Outback 2005 looks exactly like this. On the 1/2inch measurement, is that the inside or outside measurement. I measure mine at 3/4inch across. Want to get the right one! Thanks
asked by: David D
0
Expert Reply:
This # A01-2001VP would be the same as yours as the air vent is 1/2 inch inside diameter and outside diameter of 3/4 inches.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Dual RV Water Inlets - City Water and Gravity Fill - Plastic Valve
- RV Water Inlets
- City Fill Inlet
- Gravity Fill Inlet
- Surface Mount
- 1/2 Inch Deep
- Plastic
- 7-1/2 Inch Diameter Flange
- Plastic
- White
- Valterra
more information >
Continue Researching
- Q&A: Wiring Needed To Operate Winch On Trailer From Truck Battery
- Q&A: Everchill Model WD-282FWDC-B-6 RC refrigerator
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Can You Flat Tow a Ford Escape?
- Q&A: Cutout Dimensions for the Valterra City Water Inlet # A01-2001VP
- Q&A: Replacement Leaf Springs for 2011 Eclipse Stellar Toy Hauler
- Article: How Your RV Water System Works: A Complete Newbie's Guide
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Q&A: Do Trailer Slipper Springs Normally Slip Out of their Rear Hangers
- Article: How to Raise Your Travel Trailer Height
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Q&A: Troubleshooting Triple Axle Trailer with Rear Axle Off The Ground