How to Remove Dust Cap on Snowbear Utility Trailer
Question:
How do you remove the dust cap on snowbear utility trailer
asked by: Bob
Helpful Expert Reply:
The dust or grease caps on your Snowbear Utility Trailer should just pop out and in. I recommend using a flat head screwdriver to pry them out or tap them from side to side with a hammer. Then to install new ones, you can just gently hammer them in.
If you are still needing replacement grease caps, you will want to measure the inner diameter of the hub where the cap fits. I recommend using a digital caliper like # PTW80157 to get the most accurate measurement possible. For example, the TruRyde Grease Cap # RG04-060 will fit a flange diameter of 2.446 inches.
I have attached a video of a trailer hub being removed and reinstalled that you may find helpful.
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 2.441 Inch O.D.
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Disc Brake Kit And Actuator For A Grand Design 311BHS
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Q&A: Recommended E-Z Lube Hub and Rotor Assembly for 6K Axles
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Q&A: Towing Capacity of 2004 Chevy Silverado LS with 5.3L Engine
- Q&A: Purpose of Grease Caps and How to Measure to Get Correct Size
- Q&A: Distance From Rear Hole to End of Case on Demco Hydraulic Brake Actuator with Drop
- Q&A: What is the Length of the 12.5K Demco Hydraulic Disc Trailer Brake Actuator
- Article: Double-Eye Trailer Suspension System Review
- Article: Best Bike Racks for Electric Bikes
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: 2023 Best Gifts for RVers & Campers