Dimensions of Top and Bottom Plate on Stabil-Step Stabilizer Jack # JSS-4
Question:
Top and Bottom plate dimensions and mounting hole spacing. I checked Dtrombergs web site and catalog. Neither provides the info I want. I want to use them in my shop.
asked by: Carl M
0
Expert Reply:
The square surface on the top and bottom of the Stabil-Step Stabilizer Jack # JSS-4 measures 4-1/16 inch by 4-1/16 inch. This does not have mounting holes as it is not a permanent mount step.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Stabil-Step Stabilizer Jack for Step Assembly - 750 lbs - 4-3/4" to 7-3/4"
- Accessories and Parts
- RV Steps
- Jacks
- 750 lbs
- Black
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Using TPMS Flow Through Sensors And Valve Extenders On A 2024 Ford F-450
- Q&A: Where Are The Trailer Light Fuses On A 2011 Ford F-250 Lariat
- Q&A: Trailer Tire Replacement Recommendation for a 225/75/16 on Tandem Fifth Wheel
- Q&A: Replacement Steps for Flagstaff Super Lite 8538BHWS
- Q&A: Dimensions of the Torklift Rubber Camper Bumpers # TLA7001
- Q&A: Rubber Bumper that Can Be Use to Prevent RV Door From Hitting Bumper
- Q&A: How to Select Hubs That Are Compatible with Trailer Spindle
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Measure for Motorhome Steps
- Article: Trailer Tire Sizing
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Towing a Trailer? Let's Talk About Brake Controllers