Will Prodigy P2 Brake Controller Plug Into Same Connector that Prodigy Controller Uses

Question:

: Hi, I have followed the instructions to get my prodigy p2 into electric over hydraulic mode but after the second press of 5 seconds it just shows .r. again. after trying many times, i still get this result. Any suggestions as to what i am doing wrong, or what i can try to get a better result would be so much appreciated. The unit is installed in a land rover discovery 4. Thanks Hi, I just sent you through a question which i have just worked out the answer to - being i have a P1 not a P2 controller - i.e. red LED display. So my more sensible question now is do i need to change the wiring to install a P2 or P3? or does it use the same connections thus i can just swap the controller? Many thanks.

asked by: Michael M

Expert Reply:

I am glad you figured out what was going on! I would go with a P2 part # 90885 as it will plug right into the same connector your P1 uses and would use the same mount. The P3 # 90195 would still use the same harness but would require you install a new mount.

expert reply by: Jameson C