Where Is Gooseneck Ball Hole Located in Bed of 2016 GMC Sierra 3500 Long Bed for B&W Hitch
Question:
i am going to be purchasing a 2016 GMC sierra 3500 dually, it has the curt flip down ball, i want to install the BandW turnover ball, because in need the companion 5th wheel. my question is are the cutouts in the bed the same?
asked by: Dave
Expert Reply:
I pulled up the installation instructions for the # BWGNRK1016 which is a fit for your 2016 GMC Sierra 3500 and found that the hitch ball center measures 49-1/2 inch from rear and the Curt hitch you have installed would be located 47 inches from the FRONT of the truck bed. Since we don't have access to the overall length of your truck bed measured from the front of the inside of the bed to the back of the truck bed edge you will have to measure to check on your truck.
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Manual Ball Removal
- 7500 lbs TW
- 30000 lbs GTW
- Removable Ball - Stores in Hitch
- Wheel Well Release
- 2-5/16 Hitch Ball
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Options for Adding Interior Lighting to Enclosed Cargo Trailer
- Q&A: How to Power Trailer Dome Light When Not Connected to Tow Vehicle
- Q&A: How to Add Tension to Solera Slide-Topper
- Q&A: Recommended Dexter Suspension Kit 7753400
- Q&A: Is It Possible To Replace Fabric On Slide Out Awning?
- Q&A: Proper Solera Slide Topper Tension Adjustment
- Q&A: Solution for Needing Stoplight Circuit on Difficult to Find Vehicle
- Article: What Exactly is Tongue Weight?
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Charge RV Batteries
- Article: Best Bike Racks for Electric Bikes
- Article: How to Rent an RV
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Raise Your Travel Trailer Height