Can Bolt Holes of E-Track Be Skipped When Installing with Self-Tappers to Aluminum
Question:
when installing ETRACK to steel diamond plate bed with self tapping screws how far apart would place screws?
asked by: Ronald T
1
Helpful Expert Reply:
The more screws you use the better, but at a minimum I wouldn't skip more than two bolt holes with the self-tapping screws.
If it were me I would probably just go every other hole to be safe.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Erickson E-Track Wheel Tie-Down Strap with Roller Idler and Ratchet - 2" x 12' - 1,100 lbs
- Car Tie Down Straps
- 1 Strap
- 11 - 20 Feet Long
- Ratchet Strap
- 851 - 1200 lbs
- Erickson
more information >
Continue Researching
- Q&A: What is The Height From The Track To The Bottom Of The Roller on E-Track Roller Idler # e67HR?
- Article: How to Install E-Track in 3 Easy Steps
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can E Track be Used to Secure Car in Car Hauler Trailer
- Q&A: Tie Down Solution for Corvette on Open Car Hauler
- Q&A: Can E-Track be Installed in Car Hauler for Multiple Car Widths
- Article: Steel vs. Aluminum Ball Mounts
- Q&A: Installation Recommendations For E-Track Horizontal Track System In Trailer With 2x6 Floor
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Q&A: Can E-Track Be Used To Secure a Car in a Trailer?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Article: Finding the Right Electric Winch
- Article: Best Air Bag Suspension (2023)