Where is the Brake Controller Wiring Port on a 2006 Nissan Frontier
Question:
I have a 2006 Nissan Frontier that did not come with a tow package. I installed a kit I bought from the dealer that included a couple relays and a 7 pin recepticle which pluged into two existing plugs at the rear of the truck. One of which has two heavy wires that I assume are for the brakes. Will I find other plugs under the dash to install a controller with the factory plugs?
asked by: Ray
0
Expert Reply:
Your truck should have a port under the dash for connecting the brake control wiring adapter, part # 3050-S. I have added links below to the instructions that are included with the adapter that show the location of the port.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Tekonsha Wiring Adapter for Electric Brake Controllers - Nissan
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Wired to Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Continue Researching
- Q&A: Which Install Harness For P2 Brake Controller for 2023 Nissan Frontier
- Q&A: How Is Spring Bar Tension Set Up with Trailer Weight Distribution System
- Article: Trailer Wiring Diagrams
- Q&A: Oil Seal for 10K Quality Axles with Seal 27438
- Q&A: Recommended Trailer Hitch for a 2015 Mercedes-Benz M-Class ML350
- Article: Best Air Bag Suspension (2023)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Q&A: Will The Air Lift Air Bag Helper Springs # AL39DQ Fit a 2023 Nissan Frontier SV 4X4?
- Q&A: Redarc Brake Controller for 2014 Pathfinder
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)