Recommendation for 4-Step Setup to Fit 2008 Grand Junction
Question:
The current 3 step mounting box is 27 1/2 , the 4 step systems I found were 27inch or 28. Do you have any 4 steps to fit?
asked by: Elmer E
0
Expert Reply:
What you would need to do is move the current outriggers of your trailer out so that the # SMFP-4400 you referenced can fit. Otherwise we have replacements as part # LC301704.
expert reply by:
Jameson C
0
Products Referenced in This Question
Lippert Outriggers for Manual RV Steps
- Accessories and Parts
- RV Steps
- Outriggers
- Lippert
more information >
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Quad - 8" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 28-1/8 Inch Wide
- 4 Steps
- 8 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Q&A: RV Step Recommendation Where Mounting Bracket is 27-1/2 inches in Width
- Q&A: Availability of Rebuild Kit for Older Blue Ox Aventa Tow Bar BX7330
- Q&A: Replacement Drain Plug For An Atwood G6A-7 Water Heater
- Q&A: Can Base Plates Be Installed on 2016 Ford F-150 That Has Grille Guard
- Q&A: Can Base Plate Kit And Grille Guard Both Be Installed On 2021 Jeep Wrangler
- Q&A: Installation Instructions for Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0
- Q&A: Will Reese Weight Distribution System Fit on Draw TIte Shank and Vice Versa
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Measure for Motorhome Steps
- Article: How (and Where) to Connect an RV Propane Grill
- Article: The Best Towing Mirrors
- Article: Trailer Wiring Diagrams