What are the Dimensions of the of the Mounting Holes for Part # AKEBRK-12L
Question:
Hi, Are the dimensions of the inner hole and the mounting holes known? Because we have a personalized trailer so we will have to see if it fits on the spindle and the mounting plate. Best regards
asked by: Bosmans J
0
Expert Reply:
The measurements for part # AKEBRK-12L are:
Inner hole where the spindle goes has a diameter of 4-7/16 inches.
The mounting holes, center on center, are 2 inches apart.
The top two holes in the 7 bolt pattern, center on center, are 4 inches apart.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Left Hand - 12,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 12000 lbs
- Brake Assembly
- Self Adjust
- 12-1/4 x 5 Inch Drum
- etrailer
more information >
Continue Researching
- Q&A: Can Sway Control Be Used on a Trailer that Uses a Pintle Hitch Set Up
- Q&A: Replacement Tail Light For Bargman 6-1/2 Inch Oval Light
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Q&A: When is Wheel Retainer Ring Needed for Dexter Hubs and Wheels
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Troubleshooting Trailer with One Hub That Locks Up Even with Low Power on Brake Controller
- Q&A: What Are the Dimensions of the 7 Bolt Brake Mounting Flange
- Q&A: Replacement Brakes For Gooseneck Trailer With Heavy Axles
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Performance Chips and Modules