Adapter Needed for JT Strong Arm Stabilizers to Allow Full Retraction

Question:

Hi, I have a 2015 Flagstaff 831BHWSS with electric stabilizers front and rear. I see that i need the extension clips for clearance. However i am wondering if i need further parts to attach the second lock arm on the front stabilizers. The instructions only show one arm attached to the front stabilizers via the one 4inch swivel bolt.

asked by: Jaicon

Expert Reply:

To allow the Lippert electric stabilizers to retract fully when using the JT Strong Arm stabilizers # LC191025 you will need to also use the adapter set # LC314597. If not used you could run into clearance issues while towing the trailer.

The adapter allows the jacks to fully retract properly but does not change the way they work so you will be leveling side to side only unless the jacks on your trailer can each move independently of the other 3.

There would be no further parts needed to install these kit.

expert reply by: Jameson C