How to Release Brakes When Pin is Pulled on Trailer Breakaway System
Question:
hi, i pulled the cable wire on my breakaway syst prt no 20099 to see if it worked and it did, by putting the pin back in will that release the brakes again. thanks
asked by: Dean
1
Helpful Expert Reply:
The brakes will release when pushing the pin back in of the Hopkins Engager # 20099.
expert reply by:
Charles S
1
Product Page this Question was Asked From
Hopkins Engager Push-To-Test Trailer Breakaway Kit w/ Built-In Charger - Side Load - 7" Wire
- Trailer Breakaway Kit
- Kit with Charger
- Side Load
- Single-axle
- Tandem-axle
- LED Tester
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Will Firestone Air Bags Interfere if I Install a B&W Gooseneck Trailer Hitch for a 2004 Dodge 2500
- Q&A: Fit of Turnoverball Underbed Gooseneck Trailer Hitch # BWGNRK1313 with my 2006 Dodge 3500 8 Foot Bed
- Q&A: Weight Capacity of Dexter P-12 Model SLR Axle
- Q&A: Dexter P-15 SLR Axle SN D4484069 Weight Capacity and Replacement Axle
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Run an Electric Jack Off of a Trailer Battery and a 7-Way Connector
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Comparing Trailer Breakaway Switch Kits
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)