Hole Dimensions in U-Bolt Plates 117535-G and TRTP175173
Question:
Where are the hole dim. specs. Also helpful if you say how thick it is. It appears to be thicker than TRTP175173 but same specs? You provide a lot of info except when I need it. Custom re-building old boat trailer with different axle setup. So make and model info worthless.
asked by: Darryl R
Expert Reply:
The four holes in the U-Bolt Plate parts # 117535-G and # TRTP175173 are sized to accept 3/8-inch u-bolts like # 175643-Z. I went to our warehouse and measured these plates' thickness and hole diameters and found them to be 1/4-inch and 0.4-inches respectively. Note that since these items are die-formed there can be slight variances between samples.
Products Referenced in This Question
Replacement U-Bolt with Nuts for 1-3/4" Round Trailer Axles - 3/8" Diameter - Zinc Plated
- Trailer Suspension Parts
- U-Bolts
- Boat Trailer
- Snowmobile Trailer
- 2000 lbs
- Round Axle - 1-3/4 Inch
- 3/8 Inch Diameter
- 4-1/4 Inch Long
- Redline
more information >
U-Bolt Plate - 1-3/4" Diameter Trailer Axle - 1-3/4" Wide Spring - 3/8" Bolts
- Trailer Suspension Parts
- U-Bolt Plates
- Camper
- Car Hauler
- Utility Trailer
- 2000 lbs
- Round Axle - 1-3/4 Inch
- 3/8 Inch Diameter
- TruRyde
more information >
Product Page this Question was Asked From
U-Bolt Plate for 1-3/4" Round Axle - 1-3/4" Wide Springs - 3/8" Bolts - Galvanized
- Trailer Suspension Parts
- U-Bolt Plates
- Boat Trailer
- Snowmobile Trailer
- 2000 lbs
- Round Axle - 1-3/4 Inch
- 3/8 Inch Diameter
- Redline
more information >
Continue Researching
- Shop: U-Bolt Plate - 2" Wide, Square Trailer Axle - 1-3/4" Wide Spring - 9/16" Bolts
- Shop: U-Bolt Plate - 1-3/4" Diameter Trailer Axle - 1-3/4" Wide Spring - 3/8" Bolts
- Q&A: Is It Normal For One Shackle To Point Up and The Other Point Down After Replacing Equalizers?
- Q&A: Single Axle Trailer, Should the Hanger or Shackle Be on the Front of the Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Most Popular Wheel Bearings
- Article: Where to Position the Trailer Axle?
- Q&A: Best Parts to Upgrade a Harbor Freight Trailer
- Q&A: Using Hub Centric Rings on Trailer Wheels
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Q&A: What is Minimum Trailer Tire to Fender Clearance
- Article: 7 Common Questions Everyone Has About Trailer Tires