Winch Quick Connector Availability for Making Wiring Adapter Between Trailer and Truck
Question:
Im shopping for connectors for my open car carrier trailer mounted winch. I would like to end up with a panel mounted connector on the air dam on the trailer and a connector mounted under the bumper on my pick-up 2015 Silverado. Then have a Jumper cable between the two when I need it. Asking too much?
asked by: Frank B
0
Expert Reply:
What you will need to do is use quick connects like the part # BDW20133 and then the gauge wire needed for what your winch draws to make the adapter you need. You would need a total of two of the # BDW20133 so that you have enough connectors for the setup.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Winch Quick-Connect Set w/Dust Cover - 175 A - 2 ga
- Accessories and Parts
- Electric Winch
- Wiring
- Quick Connects
- 2 Gauge Wire
- Bulldog Winch
more information >
Continue Researching
- Q&A: Will the Bulldog Winch Hitch Mount with Handles Work With a Warn Electric Winch M12
- Article: How to Choose the Best Winch for You, your Boat, and your Trailer
- Q&A: Mounting Plates for Dutton-Lainson StrongArm Electric Trailer Winch, # DL25200
- Q&A: Recommended Electric Winch to Pull a 4,200-lb Boat Onto a Trailer with Rollers
- Q&A: 2005 Nissan Titan Trailer Running Lights Not Working
- Q&A: Is There a Recommended Winch Mounting Plate Thickness for a 12,000 lb Winch
- Q&A: How To Choose Correct Size Wire for 12K Winch on Rear of Vehicle
- Q&A: Winch Mounting Plate for 2 Hitch Receiver to Fit Warn M12000 Winch
- Article: How to Wire an Electric Winch
- Article: Ram Trailer Tow Prep Package
- Article: How to Choose a Battery Charger
- Article: How to Measure for Motorhome Steps